Fake Altoid Tin
28
Likes
606
Downloads
589
Views
Published on April 7, 2010
This thing was Featured on April 7, 2010
Description
This is a makerbottable altoid tin-like enclosure for MintyBoost XL found at thingiverse.com/thing:2144 Will presumably also work for other similar devices.
It's not necessary in the strict sense, but if you can't find an altoid tin you have a ready replacement. Additionally, you can alter the files to print a design or logo on the lid (in relief and thin lines only, since the top of the lid is on the bottom of the print), and you won't have to worry about insulating the board from the metal case.
It's not necessary in the strict sense, but if you can't find an altoid tin you have a ready replacement. Additionally, you can alter the files to print a design or logo on the lid (in relief and thin lines only, since the top of the lid is on the bottom of the print), and you won't have to worry about insulating the board from the metal case.
Instructions
1: Print.
2: Use.
2: Use.
License
Fake Altoid Tin by pandelume is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from pandelume
Very nice.
This is also great if you live in an country that don't have this candy :)