Slightly less insane Y Motor Mount
5
Likes
248
Downloads
456
Views
Published on April 20, 2012
Derived from
Y Motor Bracket
by triffid_hunter
Description
It's Triffid Hunter's excellent Y motor mount, but with some breakaway support added under the 5x5cm bridged section - so even if your printer can't do bridges well, it can still probably print this successfully.
Instructions
1) Print.
2) Break away the supports under the bridged section, and clear the single layer of diaphragm covering the motor mount holes.
3) Install.
2) Break away the supports under the bridged section, and clear the single layer of diaphragm covering the motor mount holes.
3) Install.
License
Slightly less insane Y Motor Mount by pelrun is licensed under the Attribution - Share Alike - Creative Commons license.
More from pelrun
More from 3D Printer Parts
You must be logged in to post a comment.