USB Cuddler
4
Likes
172
Downloads
364
Views
Published on April 20, 2012
Description
This thing cuddles a USB B Male connector and keeps it close and cozy with its female counterpart. I designed this after I noticed the USB connection to my Arduino board wiggling free. It actually disconnected during a print a couple of times. This holds the USB connector really tight and super glues to my Arduino case (http://www.thingiverse.com/thing:17647).
Instructions
1] Print.
2] Force USB connector in enough so that it can completely connect with the female plug but still sits flush on the outside of the case.
3] Super-glue in place.
4] Don't try to remove!
2] Force USB connector in enough so that it can completely connect with the female plug but still sits flush on the outside of the case.
3] Super-glue in place.
4] Don't try to remove!
License
More from QuantumConcepts
More from Electronics
You must be logged in to post a comment.