Sine Wave Spoon Holder
82
Likes
561
Downloads
1141
Views
Published on April 24, 2012
This thing was Featured on April 25, 2012
Description
This is a spoon holder to help keep dirty stir spoons off the counter while cooking. My mother use to have a small plate on the counter for this purpose. I wanted something with a little more nerd. Enter the Sine Wave.
Instructions
Note: On a thingomatic, if you use a raft, the raft will be slightly off the belt if printed at full size. Mine turned out fine doing it.
You must be logged in to post a comment.
fmotta
on
April 25, 2012
said:
STL is a better option than editing GCODE for one to comply with the suggestion of omission of raft :).
Well for my prusa using printrun this is not an option. Otherwise I would have posted an "I Made One". Sadly, I cannot since the gcode is incompatible :(
PrettySmallThings
on
April 25, 2012
said:
Could you upload an STL file? The gcode isn't terribly useful.
jamesarm97
on
April 25, 2012
said:
Is there a source file? I would like to generate my own geode so I can choose parameters such as layer height and no raft.
License
Sine Wave Spoon Holder by makinit is licensed under the Attribution - Share Alike - Creative Commons license.
More from makinit
More from Kitchen & Dining
Sorry about loading the wrong file. I have loaded the stl now.