Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
8mm Shaft Follower w/Acetal insert
Description
Experimental:
Another shaft follower for the Supa-Flat X carriage.
This part uses 1/8" x 1/2" Acetal dowel pins, McMaster 97155A426 mcmaster.com/#97155A426 for the bearing surfaces. This should give much longer wear than the printed plastic.
Another shaft follower for the Supa-Flat X carriage.
This part uses 1/8" x 1/2" Acetal dowel pins, McMaster 97155A426 mcmaster.com/#97155A426 for the bearing surfaces. This should give much longer wear than the printed plastic.
Instructions
1) Print the part
2) Insert one dowel in the hole of the top part.
3) Trap another dowel under the lower part.
4) Bolt it to your carriage plate.
You may need to trim the part with an xacto knife for best fit.
2) Insert one dowel in the hole of the top part.
3) Trap another dowel under the lower part.
4) Bolt it to your carriage plate.
You may need to trim the part with an xacto knife for best fit.
License
8mm Shaft Follower w/Acetal insert by bilsef is licensed under the Attribution - Creative Commons license.
More from bilsef
More from 3D Printer Accessories
You must be logged in to post a comment.