Pressfit Arduino Breadboard attachment case
0
Likes
92
Downloads
332
Views
Published on May 6, 2012
Description
Basic press-fit case for Arduino UNO. Drill holes in it, put double sided-sticky tape on it, or just hook it up to your breadboard (has included holes)
Instructions
1. Print
2. Press fit Arduino into it. Should fit flush and snug
3. Attach it to your breadboard, or just put rubber feet on the back
4. When removing board, use flat-head screw driver to pry off carefully
5. Smack yourself for thinking you ever needed anything more complicated than this!
2. Press fit Arduino into it. Should fit flush and snug
3. Attach it to your breadboard, or just put rubber feet on the back
4. When removing board, use flat-head screw driver to pry off carefully
5. Smack yourself for thinking you ever needed anything more complicated than this!
License
Pressfit Arduino Breadboard attachment case by USFRobotDesignME is licensed under the Attribution - Share Alike - Creative Commons license.
More from USFRobotDesignME
More from Electronics
You must be logged in to post a comment.