Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Chairs01 rev2
4
Likes
209
Downloads
410
Views
Published on May 7, 2012
Description
Chairs01 rev2
this has thicker legs and a thicker seat than the original.
It was in response to a print that partially failed and it was suggested thicker leg at weak spot.
I redid the legs from scratch to make them stronger.
set of 4 chairs for my dollhouse table.(or whatever you want them for)
There is a square included in the stl that is there for the purpose of scaling. it is supposed to be 1 foot square(in scale) adjust your scaling to suit your
************************************************
created using Truespace 3.2
I did test this, had some issues with the bridgeing. I am making a new model with supports built in where needed. when tested I will repost
************************************************
this has thicker legs and a thicker seat than the original.
It was in response to a print that partially failed and it was suggested thicker leg at weak spot.
I redid the legs from scratch to make them stronger.
set of 4 chairs for my dollhouse table.(or whatever you want them for)
There is a square included in the stl that is there for the purpose of scaling. it is supposed to be 1 foot square(in scale) adjust your scaling to suit your
************************************************
created using Truespace 3.2
I did test this, had some issues with the bridgeing. I am making a new model with supports built in where needed. when tested I will repost
************************************************
Instructions
scale to your needs,
the 1ft square is your benchmark
to help you adjust as needed.
I will be adjusting this model. (5/12/12)
************************************************
created using Truespace 3.2
I did test this, had some issues with the bridgeing. I am making a new model with supports built in where needed. when tested I will repost
************************************************
the 1ft square is your benchmark
to help you adjust as needed.
I will be adjusting this model. (5/12/12)
************************************************
created using Truespace 3.2
I did test this, had some issues with the bridgeing. I am making a new model with supports built in where needed. when tested I will repost
************************************************
You must be logged in to post a comment.
License
Chairs01 rev2 by cerberus333 is licensed under the Attribution - Share Alike - Creative Commons license.
More from cerberus333
More from Model Furniture
Now that you have your machine, you'll probably figure out many of your print problems on your own. This model should be printable without supports with some modifications. Check out my windsor chairs for some tips, especially check out the bridges under the seat. Feel free to send me a message and I'll talk you through some suggestions I have - they're a little lengthy to post here. Good luck!
Thanks, I will send a message shortly.