Test tubes holder
8
Likes
340
Downloads
378
Views
Published on May 9, 2012
Description
A simple rack that will hold up to 24 test tubes. It's designed for test tubes with a diameter of 18mm or less.
Instructions
1) Cut out the design on 4mm thick material (MDF, acrylic, ...)
2) Glue the corners into place on the edges of the first plate. Every corner consists of 2 complementary pieces.
3) Glue the top plate into position.
4) Done :)
2) Glue the corners into place on the edges of the first plate. Every corner consists of 2 complementary pieces.
3) Glue the top plate into position.
4) Done :)
License
Test tubes holder by Twabi2 is licensed under the Attribution - Non-Commercial - Share Alike license.
More from Biology
You must be logged in to post a comment.