Pillow Block X-ends for 3/8
12
Likes
723
Downloads
2043
Views
Published on May 9, 2012
Description
Here are the new AO pillow block x-ends for 3/8" ACME thread we are using on the AO-100 MendelMax variant.
These x-ends use the same 8mm pillow block bushings from Igus but has been updated for 3/8" ACME lead screw. The clamps also have holes for mounting a mechanical end-stop.
Source files can be found at download.lulzbot.com/AO-100/hardware/printed_parts/source/
Licensing
-Parts and files: GPLv3
-Images: CC BY SA
These x-ends use the same 8mm pillow block bushings from Igus but has been updated for 3/8" ACME lead screw. The clamps also have holes for mounting a mechanical end-stop.
Source files can be found at download.lulzbot.com/AO-100/hardware/printed_parts/source/
Licensing
-Parts and files: GPLv3
-Images: CC BY SA
Instructions
Needed printed parts:
-x1 AO-x-end-idle_ACME.stl
-x1 AO-x-end-motor_ACME.stl
-x2 AO-x-end-clamp_ACME.stl
Needed hardware:
-x8 M3 16mm SHCS
-x8 M3 20mm SHCS
-x5 M3 10mm SHCS
-x16 M3 Nyloc nut
-x21 M3 Washer
-x1 M5 30mm SHCS
-x1 M5 Washer
-x1 M5 Nyloc nut
-x2 608 Bearing
-x1 AO-x-end-idle_ACME.stl
-x1 AO-x-end-motor_ACME.stl
-x2 AO-x-end-clamp_ACME.stl
Needed hardware:
-x8 M3 16mm SHCS
-x8 M3 20mm SHCS
-x5 M3 10mm SHCS
-x16 M3 Nyloc nut
-x21 M3 Washer
-x1 M5 30mm SHCS
-x1 M5 Washer
-x1 M5 Nyloc nut
-x2 608 Bearing
You must be logged in to post a comment.
License
Pillow Block X-ends for 3/8 by AlephObjects is licensed under the Creative Commons - GNU GPL license.
More from AlephObjects
More from 3D Printer Parts
hi.. if I wanted to use 8mm acme instead, is it possible?