Mountable 10mm Bronze Bushing Holder
8
Likes
322
Downloads
843
Views
Published on May 10, 2012
Derived from
Mountable Igus Bushing Holder
by AlephObjects
Description
This is a variant that will hold the 10mm Self Aligning Bronze bushings in the Aleph clamping x-ends. I love the x-ends because you can swap out the bushings, but I couldn't find one for the 10mm bronze ones so I made this derivative. These will also work with the 8mm ones as the outer dimensions are the same.
Instructions
1. Print 4
2. Install the bushings into the holders
3. Mount on your x-carriage
4. If they are loose you can raise them up a little and put a little hot glue on them then slide them back in. Make sure you do this while it's mounted on the printer so the alignment is right.
2. Install the bushings into the holders
3. Mount on your x-carriage
4. If they are loose you can raise them up a little and put a little hot glue on them then slide them back in. Make sure you do this while it's mounted on the printer so the alignment is right.
License
Mountable 10mm Bronze Bushing Holder by ncbob is licensed under the Creative Commons - GNU GPL license.
More from ncbob
More from 3D Printer Parts
You must be logged in to post a comment.