Mustache and Monocle on a thin Stick
110
Likes
2048
Downloads
3062
Views
Published on May 12, 2012
Description
I love the idea of Mustache and Monocle on a stick.. but thought it could use some tweeks.
I enlarged the monocle and made the stick thinner and put it on the side.
also reduced the hight of the stick so the mustache stands out more.
* COLLAPSIBLE VERSION ADDED!!
I enlarged the monocle and made the stick thinner and put it on the side.
also reduced the hight of the stick so the mustache stands out more.
* COLLAPSIBLE VERSION ADDED!!
Instructions
print to make every occation a bit more fancey
For the collapsible version put monocle side of stick in mustache first then the handle part after (tab first) to complete assembly. should be a tight fit. best if done on a flat surfaces
(may require a bit of trimming of overhang of the tab on the monocle stick to fit it into the opening)
For the collapsible version put monocle side of stick in mustache first then the handle part after (tab first) to complete assembly. should be a tight fit. best if done on a flat surfaces
(may require a bit of trimming of overhang of the tab on the monocle stick to fit it into the opening)
License
Mustache and Monocle on a thin Stick by chefmaki is licensed under the Attribution - Creative Commons license.
What did you print this on? For some reason, this is giving my Replicator fits! At full size, it started trying to print off of the platform. When I reduced it, it started complaining about dangling edges and would send the platform diving to the bottom around the outer moustache curl. When I fixed it in NetFabb and then printed it, the Replicator would just stop printing around the moustache curl.
I'm going to update RepG + firmware as these sound more like Replicator bugs than model bugs, but it's curious!
I printed mine on a makerbot replicator.. With no rafting and a Hbp temp of 110, I had to level the build platform to pretty much touching and wipe a good amount of acetone on it first to get it to print cleanly.. But I have not experianced the problems you mentioned
Something else I tried to print stopped at a weird point once , but a rebuild of the gcode seem to fix the issue...
I'm working on a beak apart version for portability and so it will print on smaller platformed machines maybe that one will work better for you.. I'll upload It in the next couple
of days