Campfire
27
Likes
1863
Downloads
669
Views
Published on May 16, 2012
This thing was Featured on May 17, 2012
Description
There's a campfire in my Replicator! This is the campfire that was used in the stop motion animation at the end of MakerBot TV S02E05
youtu.be/k815gaeElW8
The flames can also be seen earlier in the episode as a bot accessory. This campfire goes well with the camping tent.
thingiverse.com/thing:23171
Created by Todd Blatt
youtu.be/k815gaeElW8
The flames can also be seen earlier in the episode as a bot accessory. This campfire goes well with the camping tent.
thingiverse.com/thing:23171
Created by Todd Blatt
Instructions
To print the two color version with your Replicator, use:
f1i.stl with f1o.stl
f2i.stl with f2o.stl
f3i.stl with f3o.stl
f4i.stl with f4o.stl
f5i.stl with f5o.stl
f6i.stl with f6o.stl
with the ‘Merge for DualExtrusion’ fuction.
‘Merge for DualExtrusion’ is found in the GCode menu in ReplicatorG.
Print the logs.stl by itself. The fire prints should slide right into the groove of the logs.
The included s3g files were generated for a Replicator.
f1i.stl with f1o.stl
f2i.stl with f2o.stl
f3i.stl with f3o.stl
f4i.stl with f4o.stl
f5i.stl with f5o.stl
f6i.stl with f6o.stl
with the ‘Merge for DualExtrusion’ fuction.
‘Merge for DualExtrusion’ is found in the GCode menu in ReplicatorG.
Print the logs.stl by itself. The fire prints should slide right into the groove of the logs.
The included s3g files were generated for a Replicator.
You must be logged in to post a comment.
License
Cold Fusion, lol.