TeaCup Dragon Base
12
Likes
490
Downloads
1360
Views
Published on May 16, 2012
Description
It's a little tough to set down Whystler's TeaCup Dragon, so I developed a base for it. While I was at it, I added a knob for the neck so it stays down when you move the jaw.
The base itself is a derivative of the base from Andreas' Pet Monster Valentine.
The base itself is a derivative of the base from Andreas' Pet Monster Valentine.
Instructions
After building your Teacup Dragon Puppet, print out DragonKnob.stl and glue it to the base of the dragon's neck - making sure not to get glue on the rod for moving the lower jaw. This will help keep the neck from popping up when you try and close the dragon's mouth
Print out DragonBase and DragonRing. Glue the base to the bottom of your dragon, and the ring to the bottom of the base. The dragons mouth should be closed when the base is placed on a flat surface.
Optional - print out a set of my Dragon Dentures (thing 20797) give him some teeth...
Print out DragonBase and DragonRing. Glue the base to the bottom of your dragon, and the ring to the bottom of the base. The dragons mouth should be closed when the base is placed on a flat surface.
Optional - print out a set of my Dragon Dentures (thing 20797) give him some teeth...
You must be logged in to post a comment.