Rotary tool stationery holder
64
Likes
413
Downloads
1204
Views
Published on May 17, 2012
Description
Designed to hold a Black & Decker RTX 3 rotary tool for stationary grinding,cutting, etc...
Instructions
Print the parts and use C-clamps to secure both pieces to the edge of a surface.
Stick a piece of heavy-duty Velcro on the rear holder piece and also on the rotary tool making sure they align. This will keep the rotary tool in place during operation.
Stick a piece of heavy-duty Velcro on the rear holder piece and also on the rotary tool making sure they align. This will keep the rotary tool in place during operation.
You must be logged in to post a comment.
License
Rotary tool stationery holder by ironchariot is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from ironchariot
More from Hand Tools
That grey piece at the end screws off, and the thread under it can be used to attach to a flex shaft or similar accessory. This would be better if it made use of that thread to fix the front portion. You wouldn't even have to print matching threads, just put a thin ring of plastic there and screw the grey piece back over it.
I haven't had this tool for very long so I wasn't aware of that. Good idea though, that would eliminate the need for Velcro.