Guy Fawkes for Stubby Ring-a-Thing
12
Likes
731
Downloads
1231
Views
Published on May 23, 2012
Description
Subtly show your support for the Anonymous movement with this.
EDIT: Used the wrong negative for the ring hole. Uploaded a new version. Only 6 downloads so I hope the damage was minimal.
EDIT: Used the wrong negative for the ring hole. Uploaded a new version. Only 6 downloads so I hope the damage was minimal.
Instructions
* Print the guyfawkes single color or white/black dual color version of the ring.
* Print a Stubby Ring-a-Thing in your size.
* Snap them together.
* Protect your finger's identity as you go about your seditious activities.
* Print a Stubby Ring-a-Thing in your size.
* Snap them together.
* Protect your finger's identity as you go about your seditious activities.
License
Guy Fawkes for Stubby Ring-a-Thing by cymon is licensed under the Attribution - Share Alike - Creative Commons license.
what settings were you using? I've been unable to get any black to extrude in the dual print on my Replicator even when going down to a layer height of 0.15mm, a feedrate of 20mm/s (w/acceleration), and the Cool module active.