Pen, X-Acto, and Pick Holder
by carbonbased, published
At my day job as a custom cable assembler, I use X-Acto knives and picks quite a lot but I don't like setting them down unprotected on my desk when switching between them since they are sharp and/or pointy. So this thing was made to hold them, as well as pens, brushes, and whatever other cylindrical things you might have around. The styling is a bit, um, interesting so feel free to modify.
Print with no support. I used 2mm fill spacing and the "Low" profile in Netfabb. That translates to .350 layer heights (but outside contours are half that) and 20% fill. This seemed to end up as a good, sturdy, and weighty thing without wasting a lot of filament.
Liked ByView All
Give a Shout Out
Pen, X-Acto, and Pick Holder by carbonbased is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving carbonbased a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure carbonbased would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).