Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
35L Fish Tank
10
Likes
837
Downloads
3235
Views
Published on May 27, 2012
Description
Aquarium for fish breeding, specifically marine clownfish pairs. Less of a "home" tank but more for science and aquaculture.
It's meant to be connected to a sump for filtration.
Update 25 May, 2012- Added weir variation for 6mm acrylic to this tank artwork. Cut it all at once!
Goes great with the laser-cut acrylic weir:
thingiverse.com/thing:23808
It's meant to be connected to a sump for filtration.
Update 25 May, 2012- Added weir variation for 6mm acrylic to this tank artwork. Cut it all at once!
Goes great with the laser-cut acrylic weir:
thingiverse.com/thing:23808
Instructions
1) CNC router cut the parts out of 6mm acrylic.
2) Weld the tank together with Weldon.
3) The four small pieces are to hold the lid up. Glue these onto the bottom of the top piece.
4) Plumbing- you'll need bulkhead fittings for 15mm and 25mm PVC pipe, intake and overflow respectively.
28 May- Note: not tested yet on a CNC-- but I've built the one pictured with a table saw.
In Australia, you can buy these bulkheads at Bunnings in the plumbing section.
2) Weld the tank together with Weldon.
3) The four small pieces are to hold the lid up. Glue these onto the bottom of the top piece.
4) Plumbing- you'll need bulkhead fittings for 15mm and 25mm PVC pipe, intake and overflow respectively.
28 May- Note: not tested yet on a CNC-- but I've built the one pictured with a table saw.
In Australia, you can buy these bulkheads at Bunnings in the plumbing section.
License
35L Fish Tank by sirleech is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.