Companion Cube Keychain
31
Likes
686
Downloads
1941
Views
Published on May 29, 2012
Description
I took the companion cube with hearts, and made a keychain out of it, as requested through our Etsy.
The size of the cube is 3cm per side.
If you want to purchase this item, message us and we can sell you one through our etsy! Also check out our other portal/companion cube products:
etsy.com/listing/78063455/aperture-science-portal-companion-cube?ref=shop_home_active
etsy.com/listing/110614281/portal-turret-3d-printed?ref=shop_home_active
The size of the cube is 3cm per side.
If you want to purchase this item, message us and we can sell you one through our etsy! Also check out our other portal/companion cube products:
etsy.com/listing/78063455/aperture-science-portal-companion-cube?ref=shop_home_active
etsy.com/listing/110614281/portal-turret-3d-printed?ref=shop_home_active
Instructions
Print with a bit of support, paint it if you'd like, and attach a key ring. I suggest a thin keychain, it seems like the thicker ones will leave it prone to breaking.
The OpenSCAD loads in the STL, and then you position the keychain loop. Might be useful in making other keychains.
The OpenSCAD loads in the STL, and then you position the keychain loop. Might be useful in making other keychains.
License
Companion Cube Keychain by CarryTheWhat is licensed under the Attribution - Creative Commons license.
More from CarryTheWhat
More from Keychains
You must be logged in to post a comment.