printerbot x axis spring
9
Likes
141
Downloads
727
Views
Published on May 29, 2012
Description
this is a spring to stabilise the x axis on a printrbot lc
Instructions
my x axis on my Printrbot lc was wiggling during violent direction changes, so I made this spring to sure it up a bit
Best printed using a fan from the 6th layer onwards but can be successfully printed without if your desperate.
My print quality has definitely improved since adding this and i hope yours does too
try printing two (one for each side)
IMPORTANT print at 1.2 scale as I'm still learning to get the scaling right but 1.2 works fine
Best printed using a fan from the 6th layer onwards but can be successfully printed without if your desperate.
My print quality has definitely improved since adding this and i hope yours does too
try printing two (one for each side)
IMPORTANT print at 1.2 scale as I'm still learning to get the scaling right but 1.2 works fine
You must be logged in to post a comment.
License
printerbot x axis spring by flint_read is licensed under the Attribution - Share Alike - Creative Commons license.
More from flint_read
More from 3D Printer Parts
OK YOU SHOULD BE ABLE TO PRINT THIS AT SCALE 1 TURNS OUT MY CALIBRATION WAS WAY OFF IF YOUR PRINTRBOT IS WELL CALIBRATED IT SHOULD BE FINE
sorry folks im new at this