Frog Mask Scan
0
Likes
69
Downloads
253
Views
Published on May 31, 2012
Description
A 3D scan of a cool frog mask made with 123D Catch and attached to a base to make it printable.
Instructions
At a small size (approximately a 1 inch base) this model takes about 50 mins to print. At the large default size (about 3 inch base) it takes about 5 hours. The large image shown here was printed between those two and took 2.5 hours.
License
Frog Mask Scan by gregab is licensed under the Attribution - Share Alike - Creative Commons license.
More from Scans & Replicas
You must be logged in to post a comment.