8 ohm Speaker Retainer Bracket
2
Likes
263
Downloads
554
Views
Published on May 31, 2012
Description
Needed to hold a small speaker against a piece of plastic, so I designed and printed this to do just that.
Instructions
1)Download.
2)Lookover.
3)Moan about how much of a novice designed this. (I'm an EE ok, not good with this physical objects stuff)
4)Print and sand out inside until it fits over speaker magnet snuggly.
Source from Autodesk Inventor included.
This is part of a larger project, to see everything go to: billporter.info/rebuilding-freeze-frame/
2)Lookover.
3)Moan about how much of a novice designed this. (I'm an EE ok, not good with this physical objects stuff)
4)Print and sand out inside until it fits over speaker magnet snuggly.
Source from Autodesk Inventor included.
This is part of a larger project, to see everything go to: billporter.info/rebuilding-freeze-frame/
You must be logged in to post a comment.
License
8 ohm Speaker Retainer Bracket by madsci1016 is licensed under the Attribution - Share Alike - Creative Commons license.
More from madsci1016
More from DIY
You know a Dr Rick Smith ? ? ?