GoPro hero 2 generic mount and bits
13
Likes
512
Downloads
1382
Views
Published on June 1, 2012
Description
GoPro hero 2 generic mount and bits, ive seen some on here before but i was looking to make a specific mount for my own needs, so a side effect was i had to measure up and draw out the original design and do a couple of test prints to get a good fit, so i thought i would upload them too, its a nice fit on the standard gopro camera mount, no slop and not too tight, i have included the drawing files from autocad 2004 format, i guess i could save out other formats if needed, i included a few images of my special mounts too, its easy to edit the generic dwg file to make one for your own needs, but keeping the typical gopro connection.
see it in action here
youtu.be/omsI9QdFpDc
see it in action here
youtu.be/omsI9QdFpDc
Instructions
i use cura and printed on normal settings. nothing fancy. printed in PLA.
20-30% fill, 0.2 layer 0.8 wall 0.6 bottom/top thkness, no raft/support
used a blade to cut a few stringers off. i will add a few more types, as and when i come to need them, Enjoy.
20-30% fill, 0.2 layer 0.8 wall 0.6 bottom/top thkness, no raft/support
used a blade to cut a few stringers off. i will add a few more types, as and when i come to need them, Enjoy.
License
GoPro hero 2 generic mount and bits by intensewalkera is licensed under the Attribution - Creative Commons license.
More from intensewalkera
More from DIY
did you have any problems with the overhang or did you print support?
Printed with no support, I had a few stringers to cut out at the end, but 30 seconds with a sharp knife and it's done