Shine on You Crazy Diamond
24
Likes
539
Downloads
989
Views
Published on June 3, 2012
Description
Diamond shaped LED desk lamp.
Approx. size 3 1/2" x 2 3/4" x 2 3/4"
Uses any old 5 volt cell phone charger to produce a quality visual effect.
Some electronics required.
Approx. size 3 1/2" x 2 3/4" x 2 3/4"
Uses any old 5 volt cell phone charger to produce a quality visual effect.
Some electronics required.
Instructions
Print all parts with raft, no supports required. I used 1 shell with 50% fill. Takes about 2 hours to complete this project.
Use a 5Volt, 500mA cell phone charger, with a 100ohm 1/4 Watt resistor in series and an ultra-bright LED. Slide the diffuser over led, glue down the wires and then glue the shade to the base.
Much time was spent on the diffuser to get even lighting I'm really happy with the result.
Enjoy!
Use a 5Volt, 500mA cell phone charger, with a 100ohm 1/4 Watt resistor in series and an ultra-bright LED. Slide the diffuser over led, glue down the wires and then glue the shade to the base.
Much time was spent on the diffuser to get even lighting I'm really happy with the result.
Enjoy!
License
Shine on You Crazy Diamond by gulak is licensed under the Attribution - Share Alike - Creative Commons license.
More from gulak
More from Electronics
You must be logged in to post a comment.