CNC Marker Holder
8
Likes
378
Downloads
847
Views
Published on June 4, 2012
Description
A 3 part Pilot marker holder for attaching a marker to the spindle of a cnc router.
Apart from the printed parts it needs a small spring to load the marker.
The inside diameter of the mounting collet is 75.3mm so it will obviously need to be adapted to your specific need.
Apart from the printed parts it needs a small spring to load the marker.
The inside diameter of the mounting collet is 75.3mm so it will obviously need to be adapted to your specific need.
Instructions
The parts are bolted together with M5 socket head hex bolts and nuts.
The body and cap needed to be reamed out a little for the marker to move freely, but I assume results may vary.
Printed un an UP! with .3mm z resolution
A short video of it in action: youtu.be/xfxAJ6xwE0Y
The body and cap needed to be reamed out a little for the marker to move freely, but I assume results may vary.
Printed un an UP! with .3mm z resolution
A short video of it in action: youtu.be/xfxAJ6xwE0Y
License
CNC Marker Holder by mcentric is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.