Printrbot filament guide thingy
50
Likes
0
Downloads
1727
Views
Published on June 7, 2012
Description
Guides your filament in the most gentle manner
Instructions
1 x printed guide
1 x 608 bearing
Position the guide over your filament wire. Snap in the bearing. Snap onto one of your smooth Z-rods
Tadaa! As easy as pie, and the most smooth guiding guide you can find on the thingiverse. :-)
Enjoy!
1 x 608 bearing
Position the guide over your filament wire. Snap in the bearing. Snap onto one of your smooth Z-rods
Tadaa! As easy as pie, and the most smooth guiding guide you can find on the thingiverse. :-)
Enjoy!
You must be logged in to post a comment.
VaguelyUseful
on
July 10, 2012
said:
This does actually work on a Printrbot Plus... but just barely... You have to bore out the hole to accommodate the 12mm rods, which makes the walls of this thing almost too thin. But, it works! Thanks!
Arvin
on
June 8, 2012
said:
Wonderful. If this works....I'll have your children.. :) ..well not really. That would make medical history.
I am tired of sitting there feeding my printrbot. If it even half works as well as you claim, I'll be happy. First thing tomorrow. Nah. Now!
License
Printrbot filament guide thingy by volunteerlabrat is licensed under the Attribution - Share Alike - Creative Commons license.
More from volunteerlabrat
More from 3D Printer Parts
Could you put the files up again please?