Adafruit Pi Box with Logo
7
Likes
1467
Downloads
2517
Views
Published on June 14, 2012
Description
I had to make some small tweaks to get it to cut right from Inkscape and while I was at it I added the Raspberry Pi logo to the lid. I also made the slots a bit thinner to better match the 0.093" acrylic that I found at my local hardware store.
Instructions
The svg looks fine in Inkscape but loads strange in Illustrator. I'm not sure why so I'm also uploading a pdf.
You must be logged in to post a comment.
License
Adafruit Pi Box with Logo by CaseyB is licensed under the Attribution - Share Alike - Creative Commons license.
More from CaseyB
More from Electronics
Looks great! I added a photo of mine. I too had some thinner acrylic (was supposed to be 1/10th" but was more like 0.085" and it still worked pretty great, with maybe just a tad more play on the "snap on" ends than I would have liked (but like I said- I knew going into it that my acrylic was a tad thin).
I had issues importing the svg into corel draw, so I grabbed the PDF and imported that. The logo didn't work so I had to grab an SVG from the web and set it up myself.
Thanks for the design!