by Mere, published
Ever wanted a vase that looked like a tornado? Or a tornado that's also a vase?
Well, luck smiled upon you, finally you can print one! :)
I modelled it in Maya, it's designed to be easily printable, with no external support, even with 0% fill.
More info here: http://zoltanb.co.uk/tips-and-tricks-on-preparing-complex-models-for-3d-printing/
Go on, print one!
All comments/criticism/improvements/ideas welcome! :)
You can print this as hollow, but you will need a couple of solid layers so that the bottom of the vase is closed.
- Perimeters: 2
- Solid Layers: 10
- Fill density: 0
If you want to put water in it, try spraying the inside with varnish to seal it completely. You don't want a leaky tornado... :)