bearing groover attachment for bolt hobber by elk
1
Likes
205
Downloads
376
Views
Published on June 19, 2012
Description
this is a bearing holder that replaces the front part of the bolt hobber by elk.
Instructions
You print the dremel holder as well as the bolt hobber by elk,
you take the front part out put this in and adjust the angle a bit after you screw on the bearing with an m8 bolt and some washers. use a rag to slow down the spin of the bearing so you actually cut the groove proceed slowly while adjusting the angle as times, might want to flip the bearing as well
you take the front part out put this in and adjust the angle a bit after you screw on the bearing with an m8 bolt and some washers. use a rag to slow down the spin of the bearing so you actually cut the groove proceed slowly while adjusting the angle as times, might want to flip the bearing as well
License
bearing groover attachment for bolt hobber by elk by terramir is licensed under the Attribution - Non-Commercial - Share Alike license.
More from terramir
More from 3D Printer Accessories
You must be logged in to post a comment.