Latch
1
Likes
109
Downloads
295
Views
Published on June 19, 2012
Derived from
Replicator 3mm hood and cover
by drandolph
Description
This latch eliminates the need to replace the replicator support bolt to install the front panel in drandolph's fine replicator cover.
Instructions
I used on-hand magnets for this project, but magcraft.com has sizes to fit most projects. Glue magnets into the holes so that the latch attaches to the existing side bolts and holds the door in place.
License
More from GuardToad
More from 3D Printer Accessories
You must be logged in to post a comment.