You need:
- 2 sheet of 10 mm Plywood big enough to cut it
- over 60 M6 nuts
- a lot of 20 mm wood screws

1. you have to level the place where table will be mounded
2. put bottom sheet and mount it strongly
3. cut bottom holes and groves.
4. in 10 mm holes you have to insert M6 nuts, I used hammer to do it. Nuts have to hided in holes
5. put top sheet, and mount it on corners for milling
6. cut all holes and groves
7. mount it to bottom sheet using wood screws, places to do it are marked on sheet with those shallow holes.
8. you can paint it using varnish or other paint