GHAE with offset mount for makergear hotend
3
Likes
247
Downloads
516
Views
Published on July 11, 2012
Derived from
Greg's Hinged Accessible Extruder
by GregFrost
Description
Minor tweaks to Greg's Hinged Accessible Extruder thingiverse.com/thing:8252 in order to allow using the makergear hotend with the wooden plate they provide.
The wooden plate is off center mounted by 3mm, which required a slight tweak of the base leadout and the motor mount angle to fit. It is also adjusted for 1.75mm filament.
None of the changes are destructive, you can easily get the stock extruder by setting mount_offset=0 and angle_offset=0.
The wooden plate is off center mounted by 3mm, which required a slight tweak of the base leadout and the motor mount angle to fit. It is also adjusted for 1.75mm filament.
None of the changes are destructive, you can easily get the stock extruder by setting mount_offset=0 and angle_offset=0.
Instructions
If you plan on using the makergear hotend, just print it. If not then you might as well use the original instead.
Basically this is provided as a service for anyone who is afraid of learning OpenSCAD, and to honor the GPL license.
Basically this is provided as a service for anyone who is afraid of learning OpenSCAD, and to honor the GPL license.
License
GHAE with offset mount for makergear hotend by hallenberg is licensed under the Creative Commons - GNU GPL license.
More from hallenberg
More from 3D Printer Extruders
You must be logged in to post a comment.