Ironing Board Feet
3
Likes
525
Downloads
1213
Views
Published on June 20, 2012
Description
While perhaps not the most glamourous model on Thingiverse these replacement feet for my ironing board took the wobble out of my cheap ironing board.
I've tested these on two generic ironing boards from Walmart and they press fit (29.8mm internal diameter) nicely. Your mileage (as always) may vary.
I've tested these on two generic ironing boards from Walmart and they press fit (29.8mm internal diameter) nicely. Your mileage (as always) may vary.
Instructions
1. Print set of feet
2. Press fit to iron board legs
3. Iron
4. Coz' every girl's crazy 'bout a sharp dressed man.
2. Press fit to iron board legs
3. Iron
4. Coz' every girl's crazy 'bout a sharp dressed man.
You must be logged in to post a comment.
License
Ironing Board Feet by TheNewHobbyist is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from TheNewHobbyist
More from Household Supplies
Good job. What about making one side have a flat portion so it sits on the floor and perhaps slides less on hardwood floors?
You're right that would be a good addition. I was duplicating the one remaining cap I had when I modeled this but a flat end would be a nice improvement.