Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
uniX-Carrier (Prusa)
12
Likes
472
Downloads
1338
Views
Published on June 24, 2012
Description
A quick mashup of kuehlings reinforced and my uniX Carriage
* open frame for easier Hotend mounting
* Optimized for uniX-Wade thingiverse.com/thing:25416 , (should work with any other Hotend / not tested)
* fan mount for extruder/coldend cooling
I don`t own a Prusa ! therefore i made it "work in progress"
so if someone wants to test it please give me a feedback how it works (or if it works at all XD )
* open frame for easier Hotend mounting
* Optimized for uniX-Wade thingiverse.com/thing:25416 , (should work with any other Hotend / not tested)
* fan mount for extruder/coldend cooling
I don`t own a Prusa ! therefore i made it "work in progress"
so if someone wants to test it please give me a feedback how it works (or if it works at all XD )
Instructions
* Carrier don`t need to be printed with support
* Fan-Clip requires Support to print.
* middle plate needs to be removed
* rest of Hotend mounting is the same as with the original uniX / reinforced carriage
* Fan-Clip requires Support to print.
* middle plate needs to be removed
* rest of Hotend mounting is the same as with the original uniX / reinforced carriage
You must be logged in to post a comment.
ttsalo
on
August 12, 2012
said:
Nice job! Fits on a Prusa I2 just fine and together with the uniX extruder is a lot more compact setup than the Prusa standard X-carriage and a Wade.
The only problem is the fan mount. Firstly it has reinforcing ribs that prevent inserting it into place. These can be removed, but after that the mounting plate for a groovemount extruder totally prevents using the fan. I'll have to put the fan in there with some other method...
License
uniX-Carrier (Prusa) by Chri is licensed under the Attribution - Share Alike - Creative Commons license.
More from Chri
More from 3D Printer Parts
Hello, could you please add SCAD file as well? I found a problem while assembling Prusa with
http://www.thingiverse.com/thi... X ends.
When I install belt, big gear of extruder touches top line of belt. Not possible to operate. I need to turn in way of fan mount hole, more parallel to belt.