Ultimaker Fan-Duct
23
Likes
373
Downloads
2200
Views
Published on June 24, 2012
Description
Replacement fan-duct for the ultimaker 3d-printer. It is easy to print and works pretty good.
Instructions
No instructions provided.
You must be logged in to post a comment.
engrkris
on
December 22, 2012
said:
100% infill + retraction, worked great. I also turned down the speed and temp to the default Cura settings, 50mm/s and 220 degrees. The fan duct works great (at least compared to the folded pos). Regarding getting it off the bed, I've been using two layers of tape and the wider tape, just peel the top layer of tape off the bed, then peel the tape off the part.
License
Ultimaker Fan-Duct by Toni is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Parts
Love the design, but it creates a lot a of back pressure and I burnt through 2 fans. This might work better with a 50x15mm fan instead of the stock sized 15x10mm.