90° Frame Jig/Clamp
23
Likes
1201
Downloads
1096
Views
Published on June 24, 2012
Description
Holds a 90° joint in place while the glue dries. Meant to be used after you biscuit or peg joint the pieces.
Instructions
1) Print one of each part.
2) Drill out the holes in both jig parts so a 5/16" rod slides smoothly through.
3) Insert a 5/16" nut into the Nut Lock™.
4) Insert the Nut Lock™ into the outer jig piece.
5) Thread a 5/16" rod through the inner jig piece and into the outer jig piece, engaging the rod with the nut in the Nut Lock™.
6) On the inner end of the rod, add a 5/16" washer, nut, washer, nut. Tighten the nuts together. The outer nut can now be used to tighten the jig.
2) Drill out the holes in both jig parts so a 5/16" rod slides smoothly through.
3) Insert a 5/16" nut into the Nut Lock™.
4) Insert the Nut Lock™ into the outer jig piece.
5) Thread a 5/16" rod through the inner jig piece and into the outer jig piece, engaging the rod with the nut in the Nut Lock™.
6) On the inner end of the rod, add a 5/16" washer, nut, washer, nut. Tighten the nuts together. The outer nut can now be used to tighten the jig.
License
90° Frame Jig/Clamp by QuantumConcepts is licensed under the Attribution - Creative Commons license.
More from QuantumConcepts
More from Hand Tools
You must be logged in to post a comment.