Harddisc 2.5 case
5
Likes
257
Downloads
829
Views
Published on June 27, 2012
Description
This is my harddisc out of my old laptop, now I use it as a backup hard disc so I needed a case. Since I own a laser cutter I made a case for it. It's made from 2mm acrylic.
Instructions
1. Put your engravings on the case an laser the dxf or cdr file.
2. Attach the side parts with holes to the hard disc with m3 screws.
3. Put glue in the slots and place the bottom, top and back part in the slots.
4. Wait until the glue is dry, then you can, if you want to, change the screws from the side to the bottom. (watch out for scratched from the screws!)
5. If engraved, use a dry/whiteboard marker and fill the engravings, then wipe it of with a tissue.
6. Enjoy your own made hard disc case!
2. Attach the side parts with holes to the hard disc with m3 screws.
3. Put glue in the slots and place the bottom, top and back part in the slots.
4. Wait until the glue is dry, then you can, if you want to, change the screws from the side to the bottom. (watch out for scratched from the screws!)
5. If engraved, use a dry/whiteboard marker and fill the engravings, then wipe it of with a tissue.
6. Enjoy your own made hard disc case!
License
Harddisc 2.5 case by jjshortcut is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from jjshortcut
More from Computer
You must be logged in to post a comment.