iPad Backseat Cinema
43
Likes
816
Downloads
2800
Views
Published on June 27, 2012
This thing was Featured on June 29, 2012
Description
This iPad holder is designed to be placed on the headrest of the two front seats in a car, for the passengers on the backseat to enjoy a movie. I have made a derivative so it is possible to place the iPad on just a single frontseat - but this original version fits my needs for the coming holiday. Feel free to derive or suggest improvements :)
Instructions
Print the parts on your 3d-printer. Try to follow how I positioned the parts to ensure best rupture strength for the individual parts. Use a power drill to make the hole go through in part B.
Then get the following from your hardware store:
2x64cm 10mm Aluminum Tube (Might be shorter if you want to try a derived design with only one carseat)
5 pcs M4 30mm (or preferred 25mm) bolts
5 pcs M4 nuts
2 pcs M8 40mm bolts
2 pcs M8 nuts
Follow the images if you are unsure how to assemble the kit.
Then get the following from your hardware store:
2x64cm 10mm Aluminum Tube (Might be shorter if you want to try a derived design with only one carseat)
5 pcs M4 30mm (or preferred 25mm) bolts
5 pcs M4 nuts
2 pcs M8 40mm bolts
2 pcs M8 nuts
Follow the images if you are unsure how to assemble the kit.
License
iPad Backseat Cinema by hein0170 is licensed under the Attribution - Non-Commercial - Creative Commons license.
Hope the person in the middle doesn't forget her seatbelt..