baby elephant
25
Likes
470
Downloads
1862
Views
Published on June 27, 2012
Description
A baby elephant
intended to be able to make a small print (to show printing in a fast print I can give to the viewer in a few minutes)
I ran this off as a 1 inch high print no infill with 3 shells in under 15 minutes.
Modeled in sculptris, then flatbottom cut in Truespace 5
intended to be able to make a small print (to show printing in a fast print I can give to the viewer in a few minutes)
I ran this off as a 1 inch high print no infill with 3 shells in under 15 minutes.
Modeled in sculptris, then flatbottom cut in Truespace 5
Instructions
size as desired
I made one small (1 inch) with 0 infill and 3 shells
The tusks and trunk get rough at that scale.
The MUCH bigger one is roughly 130 mm (5 inches)
with the same 0% infill and 3 shells .
I made one small (1 inch) with 0 infill and 3 shells
The tusks and trunk get rough at that scale.
The MUCH bigger one is roughly 130 mm (5 inches)
with the same 0% infill and 3 shells .
License
baby elephant by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Animals
awesome..my 2 year old loves it
thanks,
Post a pic if you can.