Lamppost light sensor holder
1
Likes
119
Downloads
376
Views
Published on June 28, 2012
Description
I needed to install a new light sensor on my front lawn lamppost, but the one I bought didn't fit in the old one's mount. Hence this thing. I used some J-B Weld to make a watertight seal between the sensor and the holder after installing it.
Instructions
Measure your lamppost's diameter, the size of the screws you'll use, the separation of the screw holes, and the diameter of the new sensor. Update the relevant values in the SCAD file. You'll probably have to play around with the height, depth, and angle values to get something that both looks good and is sturdy enough. The part is rotated so that no support material should be needed.
License
Lamppost light sensor holder by gmaslov is licensed under the Attribution - Non-Commercial - Share Alike license.
More from Replacement Parts
You must be logged in to post a comment.