Jetty Firmware Parametric Acceleration Calibration Tests
11
Likes
1257
Downloads
840
Views
Published on June 29, 2012
Description
These are some basic acceleration tests we were using whilst developing the acceleration firmware.
All are parametric.
We were also commonly using the squirrel and owl that can be found on Thingiverse.
10mm Calibration Cube - Quick to print thin cube (used to adjust fill during acceleration)
Calibration Cone - Used to check print quality versus speed and ringing
Calibration Cylinder - Used to check ringing and small movements
SkipTest - Used to check filament skipping in acute angles
All are parametric.
We were also commonly using the squirrel and owl that can be found on Thingiverse.
10mm Calibration Cube - Quick to print thin cube (used to adjust fill during acceleration)
Calibration Cone - Used to check print quality versus speed and ringing
Calibration Cylinder - Used to check ringing and small movements
SkipTest - Used to check filament skipping in acute angles
Instructions
No instructions provided.
License
Jetty Firmware Parametric Acceleration Calibration Tests by jetty is licensed under the Attribution - Share Alike - Creative Commons license.
More from jetty
More from 3D Printing Tests
You must be logged in to post a comment.