40mm Fan Duct for Lulzbot Prusa
21
Likes
962
Downloads
1864
Views
Published on July 11, 2012
Derived from
Adjustable-angle Brix's Fan Mount
by hexagon5un
Description
40mm Fan for Lulzbot Prusa
Also secures X belt with fan mount.
Alibre PE source files included.
MendelMax 1.5+ kits and printed parts are available for purchase at ultibots.com.
Also secures X belt with fan mount.
Alibre PE source files included.
MendelMax 1.5+ kits and printed parts are available for purchase at ultibots.com.
Instructions
Print and enjoy!
You must be logged in to post a comment.
zetakiel
on
December 6, 2012
said:
I printed your Fan Duct, I'll try to use this to print small gears. I'm considering the decition to print your last model of fan duct but I have a prusa mendel v1.0 of lulzbot, could it fit?
zetakiel
on
December 5, 2012
said:
so you connect your fan to D9 of your RAMPS and that fan is controlled with configurations set in Slic3r?
License
40mm Fan Duct for Lulzbot Prusa by Ultibots is licensed under the Attribution - Share Alike - Creative Commons license.
More from Ultibots
More from 3D Printer Accessories
I've noticed improvement in the quality of my prints, but if there are very small layers that needs full speed of the fan when I print it using the marlin firmware It tells me that cold extrusion is not allowed
zetakiel -
Glad to hear the design is working for you. Try Eric the creator of Marlin on FreeNode #reprap. His IRC nickname is EvdZ. I haven't had this firmware issue. - Brad