Simple fillament roll holder
1
Likes
191
Downloads
273
Views
Published on July 12, 2012
Description
Simple holder to put a roll of fillament on.
Instructions
You need 4 M4 screws of about 25mm length, 8 small and 8 large washers and 4 8mm bearings. Just stick one small washer, one large, one bearing, one small washer and then again one large washer on one screw, place it n the inside into one of the printed holes. Repeat until all four holes are filled Voila :)
License
Simple fillament roll holder by Srek is licensed under the Attribution - Share Alike - Creative Commons license.
More from Srek
More from 3D Printer Accessories
You must be logged in to post a comment.