RC 1/10 buggy-truggy rim
7
Likes
281
Downloads
702
Views
Published on July 12, 2012
Description
Rc 1/10 standard buggy / truggy wheel.
width : 50mm
inner tyre diameter : 58mm
2 holes for air pressure
standard hex mounting 4mm depth
width : 50mm
inner tyre diameter : 58mm
2 holes for air pressure
standard hex mounting 4mm depth
Instructions
be careful at the begining of the print because of some slope being less 45°
take 3hours (feed rate 23mm/s) on an huxley with 0.5mm nozzle and 0.33mm layer (infill 0.2 rim weight 26gr)
Not yet tested on track but fit well the car.
Ask if you want the solidwork source.
17/07/2012 : new version better/easier and faster to print.
06/02/2013 : added a 72mm as asked.
take 3hours (feed rate 23mm/s) on an huxley with 0.5mm nozzle and 0.33mm layer (infill 0.2 rim weight 26gr)
Not yet tested on track but fit well the car.
Ask if you want the solidwork source.
17/07/2012 : new version better/easier and faster to print.
06/02/2013 : added a 72mm as asked.
You must be logged in to post a comment.
License
RC 1/10 buggy-truggy rim by crazytiti is licensed under the Attribution - Share Alike - Creative Commons license.
More from crazytiti
More from R/C Vehicles
Could you make one with a 72mm tire Dia?
is this what you need ?