Universal Spool Roller (86 to 102 mm Width)
27
Likes
273
Downloads
1452
Views
Published on July 12, 2012
Description
I have small and big rolls and needed a holder for both of them.
As i just recently got some 608 bearings i mixed it with designs i found here on thingiverse.
As i just recently got some 608 bearings i mixed it with designs i found here on thingiverse.
Instructions
no raft needed :) you will need a drill to free the holes for the screws as i put support in there.
You must be logged in to post a comment.
Collections
Things to Make
by rs7k
My RepRap Parts
by Okatake
Replicator Upgrades - Spool Rollers
by garyacrowellsr
License
Universal Spool Roller (86 to 102 mm Width) by dynai is licensed under the Attribution - Share Alike - Creative Commons license.
More from dynai
More from 3D Printer Accessories
I like this sort of roller stand, but all the ones I've seen suffer from a bad flaw - any part of the stand that is higher that the roller(s) will hit the filament of a full spool. What's need is a design that is a solid roller (or lots of bearings) from one side to the other so that there is nothing sticking up in the filament area.
Perhaps if the 608 bearing supports inside the filament area were chopped off to be just U shaped channels to hold the axle/bolt up it would eliminate the interference while still supporting the inside end of the axle/bolt.