Arduino + Shield wall mountable enclosure
8
Likes
472
Downloads
1161
Views
Published on July 13, 2012
Description
My first 'thing'. Designed as a prototype for an accurate weight dispensing system which will be used to measure amounts of gunpowder that goes into speciality fireworks but the case itself will hold an arduino microprocessor and a shield to perform any manner of tasks with different panels cut for different arduinos/shields.
Created in Sketchup
Created in Sketchup
Instructions
Printed on the UP! 3D printer with support
I found it was best to print vertically so the sides had the best finish
The two end caps were printed flat with the raft 'mess' on the inside
the grey aluminium look panel are 1.7mm plastic with slots cut out using a mechanical press
I found it was best to print vertically so the sides had the best finish
The two end caps were printed flat with the raft 'mess' on the inside
the grey aluminium look panel are 1.7mm plastic with slots cut out using a mechanical press
License
Arduino + Shield wall mountable enclosure by mryoungcollins is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from mryoungcollins
More from Electronics
You must be logged in to post a comment.