Chattering Teeth - manual version
28
Likes
483
Downloads
1120
Views
Published on July 13, 2012
Derived from
ChatterBox Teeth - Wind-up
by Renosis
Description
These teeth are made to be manually operated to chatter without the need for a windup component. They were made with The Replicator and then bent with a heat gun into position. I gave these to a 'special visitor' who was being interviewed here this evening for a German TV show.
Created by Todd Blatt
Created by Todd Blatt
Instructions
Carefully heat the bridge between the two halves to bend the part into the right shape. Glue in teeth.
-Todd
-Todd
You must be logged in to post a comment.
License
Chattering Teeth - manual version by MakerBot is licensed under the Attribution - Share Alike - Creative Commons license.
I've worked out the "laying flat problem" by importing the model into another program and slicing it down to lay flat. The current problem I'm running into is the "teeth" have rounded "roots" and the "gums" have squarish holes. So it takes significant manipulation to force the teeth to fit into the "gums".
Get your dremels ready boys because you are going to need it.