Genie Bottle
42
Likes
1601
Downloads
3055
Views
Published on July 31, 2012
Description
A four part bottle, Genie not included.
Shown here in MakerBot's Green Sea ABS and Stone ABS. Two of these parts are made with DualStrusion.
Created by Todd Blatt
Shown here in MakerBot's Green Sea ABS and Stone ABS. Two of these parts are made with DualStrusion.
Created by Todd Blatt
Instructions
The lamp was designed for DualStrusion.
Use:
genie base white.stl with genie base green.stl
genie top white.stl with genie top green.stl
genie middle.stl and genie cap.stl are both single color models.
The top middle and bottom sections were glued together after they were made. The top piece is made upside-down for balancing purposes. The genie cap.stl is made with a large breakaway mouse ear just in case it tips over.
Don't worry about the holes near the top of the model; genies can't fit out through those holes, only through the top of the bottle.
-Todd
Use:
genie base white.stl with genie base green.stl
genie top white.stl with genie top green.stl
genie middle.stl and genie cap.stl are both single color models.
The top middle and bottom sections were glued together after they were made. The top piece is made upside-down for balancing purposes. The genie cap.stl is made with a large breakaway mouse ear just in case it tips over.
Don't worry about the holes near the top of the model; genies can't fit out through those holes, only through the top of the bottle.
-Todd
License
is there a way you can upload one in a single color print :) for us old fashioned printer guys :)
There ya go! I made a similar version for single extrusion: http://www.thingiverse.com/thi...