Bowden clamp with holder for electronics
by dinac, published
Bowden clamp for Ultimaker prevents popping out PTFE tube.
It has holder for thermocouple circuit.
With short tube thread for those who cuted few time PTFE tube and now head want go in 0,0 position because of short tube.
I made this with holder for electr. for those who want to have thermocouple board and Bowden clamp together.
Good thing with this design is for those who few times cuted PTFE tube and now head is not going to 0,0 position because of shorten tube.
I assume that you dont need specialy manual how to mount , because your tube poped many times, and you did this many times :D :lol:
First at all pull the tube through the nut !
Next you must mount thermocouple board - nuts goes in position at the bottom of the base
Then you can mount tube in white clamp and put blue clip
After that you can assemble the base.
Since circuit board is large dimensions, all is made that suit in milimeter.
Mounting is with existing bolts.
I printed all this in 0,1mm and it holds the tube like hell.
Thread of nut is also new, so I assume that you cant use old, but before printing you can check if it suits.
Liked ByView All
Give a Shout Out
Bowden clamp with holder for electronics by dinac is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure dinac would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).