MendelMax Y belt / pulley shield
18
Likes
372
Downloads
919
Views
Published on July 26, 2012
Description
Cover up the Y pulley and belt if you're going to be sticking your fingers near it a lot.
Especially useful with a panel or cords that are near by, like this: thingiverse.com/thing:27354
Especially useful with a panel or cords that are near by, like this: thingiverse.com/thing:27354
Instructions
Print.
Attach to motor.
I made it to fit over the MendelMax 1.5 motor mount.
The little feet that don't fit are there just for bridging, snap them off.
Attach to motor.
I made it to fit over the MendelMax 1.5 motor mount.
The little feet that don't fit are there just for bridging, snap them off.
You must be logged in to post a comment.
License
MendelMax Y belt / pulley shield by mfinn is licensed under the Attribution - Non-Commercial - Share Alike license.
More from mfinn
More from 3D Printer Parts
Excellent part, printed and nice fit after drilling the holes to m3.