London 2012 Stand for Parametric Rings
7
Likes
760
Downloads
418
Views
Published on July 28, 2012
Derived from
Parametric Rings
by Yuleblinker
Description
A stand for some 30mm Paramatric Rings.
The stand has LONDON 2012 embossed on the front and back. You can use it to display a set of assembled coloured rings or for a solid set of single colour rings.
I printed the stand out using Robot Silver PLA from Faberdashery.
The stand has LONDON 2012 embossed on the front and back. You can use it to display a set of assembled coloured rings or for a solid set of single colour rings.
I printed the stand out using Robot Silver PLA from Faberdashery.
Instructions
Print:
Individual Rings
1 x blue_ring_30mm.stl
1 x yellow_ring_30mm.stl
1 x black_ring_30mm.stl
1 x green_ring_30mm.stl
1 x red_ring_30mm.stl
(use the rings with 'gap_support' if you want to reduce the risk of warping. You'll need to trim the support material if you do)
or
Solid linked rings
1 x linked_rings_solid_30mm
Base
1 x London_2012_base_for_30mm_linked_rings.stl
Clean up
Use a sharp craft knife and/or file to remove any support material. You may need to file or sand the places where the rings link together.
Assemble
Link the rings together and insert into slots in the base.
Individual Rings
1 x blue_ring_30mm.stl
1 x yellow_ring_30mm.stl
1 x black_ring_30mm.stl
1 x green_ring_30mm.stl
1 x red_ring_30mm.stl
(use the rings with 'gap_support' if you want to reduce the risk of warping. You'll need to trim the support material if you do)
or
Solid linked rings
1 x linked_rings_solid_30mm
Base
1 x London_2012_base_for_30mm_linked_rings.stl
Clean up
Use a sharp craft knife and/or file to remove any support material. You may need to file or sand the places where the rings link together.
Assemble
Link the rings together and insert into slots in the base.
License
London 2012 Stand for Parametric Rings by AndrewCraigie is licensed under the Attribution - Creative Commons license.
More from AndrewCraigie
More from Signs & Logos
You must be logged in to post a comment.